Ponto 3
Slide the connector loop UP through the lower hole in the bottom part of the BAHA (a).
Using a pair of needle nose pliers, pinch the opening closed (b) & (c).
Ponto 4/5
- Thread open filament end through a crimp bead.
- Thread end of the filament through the safety line hole.
- Thread the end of the filament line back through the crimp bead again. Pull filament line and move the crimp bead towards the Rondo until the two crimp beads are snugged up against each other.
- Use a needle nose pliers to squeeze the crimp bead until it is totally flat.
- Attach clasp to loop.
PLEASE NOTE: I do not have a demo of the Ponto4/5, a similar processor is shown for clarity.
